It is advised to always run this command with the WhatIf parameter if not targeting a specific rule or set of rules. Enable-NetFirewallRuleLike the Disable-NetFirewallRule, this command will enable a previously disabled rule or set of rules.If this command is run without any parameters it will enable all previously disabled rules.The rule will still exist, but not actively modify any network data.If you run this command without any parameters, it will disable all active rules on the target computer. Disable-NetFirewallRuleThis will disable a previously enabled firewall rule.Copy-NetFirewallRuleThis command will copy an existing firewall rule and all associated filters to the same or different policy store.Though we don’t cover them all here, a few notable commands are shown below to demonstrate how extensive the module is. There are many other commands available within the NetSecurity module.
0 kommentar(er)
